Publicidad
Idiomas disponibles
Idiomas disponibles
REQUIRED LOCK: Master Lock
INSTRUCTIONS:
1. Select mounting configuration based on your lock
(round hole = Master Lock
2. Unbolt padlock tab
3. Insert lock shackle into correct hole (round or square) in padlock tab
MASTER LOCK
®
#5
1-7/16" (36 mm)
1-3/16" (30 mm)
2-1/4" (57 mm)
Round hole for 11/32" - 3/8" (8.7-9.5 mm) diameter shackle
Figure 1
SIDE VIEW
LOCK INSTALLATION
®
#5 or #1 (or equivalent size) – REQUIRED TOOL: 1/2" wrench
®
#5; square hole = Master Lock
11/32"- 3/8" (8.7 -9.5 mm)
7/8"- 1-1/8" (22-29 mm)
Padlock Tab
TO INSTALL RAPID PASS™ RUBBER HOLE PROTECTOR
TOOLS REQUIRED- Hammer and flat blade screwdriver.
1. Locate the "knockout"
2. With a screwdriver and hammer, carefully punch out the "knockout" from the
inside of the box so that metal ring will fall outside box (figure 1).
3. Place the "Rapid Pass"™ rubber hole protector from the outside of the box in
the hole and be sure that it is properly seated. BE SURE NO SHARP METAL
EDGES ARE EXPOSED (figure 2).
4. When passing cords into the box, be sure to always enter box from the rear.
After head of cord is in place, slightly pull back 2-3" to ensure weather resistant
"star bursts" are facing toward the outside of box (figure 3). Never push the cord
from inside the box so that mating plug points are exposed to the environment
5. BE SURE TO FOLLOW ALL ELECTRICAL SAFETY PRECAUTIONS.
Figure 2
INTERIOR VIEW
4. Insert bolt into padlock tab
®
#1)
5. Attach lock nut
6. Test locking mechanism
MASTER LOCK
®
#1
15/16" (24 mm)
2-1/4" (57 mm)
Square hole for 5/16" (8 mm) or less diameter shackle
2
5/16" (8 mm)
1-3/16" (30 mm)
7/8"- 1-1/8" (22-29 mm)
Padlock Tab
Figure 3
EXTERIOR VIEW
Publicidad
