Publicidad
Idiomas disponibles
Idiomas disponibles
3. PRODUCT DESCRIPTION
1.
Handle
2.
Charging port
3.
Mounting recess
4.
Dust cup lid
5.
Dust cup
6.
Dust cup lid release button
7.
Dust cup release button
8.
Inner tube release button
9.
Telescopic tube
10.
Castor
11.
LED lights
12.
Motorised floor brush
13.
Floor brush release button
4. INSTALLATION AND ASSEMBLY
4.1. INSTALLING THE WALL MOUNTING BRACKET
The product is designed to sit in the wall mounting bracket vertically.
1.
Choose a suitable indoor location for the wall mounting bracket.
2.
Mark and drill two mounting holes in the wall.
3.
For a concrete/brick wall only, fit the supplied wall plugs into the mounting
holes. Skip this step for a wooden wall.
4.
Attach the wall mounting bracket to the wall using screws.
Note: Do not drill into pipes or main cables beneath the surface during preparation for mounting
holes. The fixing points must be capable of supporting the product's total weight.
4.2. ASSEMBLING THE HAND-STICK VACUUM CLEANER
1.
Insert the tube into the floor brush connector and push it until it clicks into place.
2.
Insert the main body into the top of the tube and push it until it clicks into place.
3.
Adjust the tube length to suit your height. To do so, press and hold the inner tube release button
on the outer tube and pull or push the inner tube.
4.3. ATTACHING AND DETACHING ACCESSORIES
CAUTION: Before changing accessories, always switch the vacuum cleaner off first.
CAUTION: Risk of injury! Never hold the crevice nozzle close to the body, or it may stick to the
skin. If the nozzle does get stuck, switch off the appliance immediately.
•
All the 3 accessories (crevice nozzle, 2-in-1 round brush nozzle, and floor brush) can be
attached to the tube or directly to the main body.
14.
Tube release button
15.
Air outlet
16.
LCD screen
17.
Suction power button
18.
On/Off button
19.
Hook for main body
20.
Cord holder
21.
Wall mounting bracket
22.
Crevice nozzle
23.
2-in-1 round brush nozzle
24.
Battery charger
9
EN
Publicidad
