Publicidad
Assembly
1
Attaching the seat and back
□
Attach the chair back (B) and chair seat (A) using
four hex bolts (AA) and metal washers (CC).
Tighten with the hex wrench (EE).
□
Cover each bolt with the plastic bolt caps (DD).
NOTE: Tighten each bolt a few revolutions at a time,
alternating between bolts in a cross corner (X)
pattern to ensure your chair frame is level.
Attaching the triangular
2
bracket
NOTE:
Bolts must be inserted from underneath the
seat (closest to seat fabric or straps) through the
crossbar into the triangular bracket (BB).
□
Attach the triangular bracket (BB) to the chair seat
(A) crossbar using four bolts (FF), the rectangular
steel plate (HH), chair seat crossbar (A), lock
washers (GG), and nuts (II) as shown in the image
below. Tighten using wrench (LL).
CAUTION: Please ensure the triangular bracket is
installed in the correct position as illustrated.
□
Cover each bolt with bolt cap (KK) and plastic nut
cap (JJ).
6
Publicidad
