Assembly
1
Attaching the legs to the rim
□
Align the table rims (E) side by side so that the
umbrella hole is in the middle. Attach the leg
support (A), table leg (B), and table rim (E) using
twelve hex bolts (CC) and metal washers (DD). Do
not tighten bolts completely.
NOTE: Do not tighten the bolts fully until all parts are
attached on the underside of the table frame.
2
Securing the connections
□
Secure the table rim (E) using four hex bolts (BB),
nuts (II), and metal washers (DD). Do not tighten
bolts completely.
NOTE: Do not tighten bolts until all parts are
attached on the underside of the table frame.
6