AquaTru ATU100 Manual Del Propietário página 14

System Maintenance: Filters
ST EP
8
Turn on the tap water:
Slowly turn on your cold water supply, then open the tap water adaptor valve,
(turn counterclockwise) to allow untreated water to enter the system.
CHECK FOR LEAKS!
Open RO holding tank valve:
Open the tank's ball valve to allow water to enter the tank. The tank's valve is "ON" when
the valve handle is parallel (in the same direction) with the valve outlet.
CHECK FOR LEAKS!
Wait for the tank to fill:
Before usage, fill the RO holding tank and empty it completely two times. Allow 2 to 3 hours
for the tank to fill. When the tank is filled, the RO system will shut off automatically.
CAUTION:
When the unit is first filled with water, some tiny black particles are flushed out of the
carbon filter. It's important that you fill the RO holding tank and empty it out 2 times
before consuming the water.
Drain Tank:
Open the RO water faucet to drain the tank. Let the tank drain completely
before closing the lever.
CHECK FOR LEAKS!
Make sure there is no leaking at the joint, fitting, valve and tubing connections.
END OF INSTALLATION
AquaTru ® ATU100 is certified
against ANSI/NSF Standard 42,
53, 58, 401 & P473 to remove 74
contaminants as specified in the
performance data sheet.
Aquatruwater.eu / Aquatru.co.uk
13
Under Sink / Instructions