Descargar Imprimir esta página

AquaTru ATU100 Manual Del Propietário página 16

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 96
System Maintenance: Sanitizing the RO Holding Tank
ST EP
9
Sanitize RO holding tank:
The RO system should be sanitized once a year. We recommend that you do the sanitizing process each
time you replace the VOC filter, every 12 months. You should complete the sanitizing process before you
replace the VOC filter. Please do the following.
For best results – We recommend that you use 15 ml of household bleach. To ensure that the tanks get
sterilized, check that the bleach hasn't expired. If it has expired, buy new bleach.
Tips before you start:
1.
Make sure you have sanitizing solution and a new VOC filter.
2. Ensure the surface area is free of any excess dirt or dust in order to not cross contaminate parts.
3. Wash hands with soap and water and/or wear sanitary gloves.
How to Sanitize Your RO Holding Tank
1.
Turn off the cold water supply line to the RO system.
2. Open the RO water faucet, and drain the water out of the RO holding tank. Before proceeding,
make sure that the tank is completely empty.
3. Unscrew the top cap of the TruPure holding tank sanitizer.
empty, the RO holding tank and sanitizer is pressurized and will spray water when opened.
4. Pour 15 ml of bleach into the tank sanitizer. If there is too much water
in the sanitizer to add bleach, pour the water out before adding the bleach.
5. Reconnect the top cap on the tank sanitizer, make sure that it is on tight.
6
Turn off the RO water faucet.
7.
Turn on the cold water supply line for the system to fill the RO system.
CHECK FOR LEAKS!
8. Allow 2 hours for the RO holding tank to completely fill.
9. Empty the RO holding tank by opening the RO water faucet.
10. Refill the RO holding tank again and close the cold water supply line.
11. Empty the RO holding tank.
12. Replace the VOC filter and other filters as needed.
Helpful Hint: Write the date on the filter you replaced and notate it in our helpful Filter
Replacement Records chart on the last page of this manual, so you can easily remember
when it needs to be replaced again.
13. After replacing a filter, run two full tanks of water through the filter and drain the water out
before comsuming the water.
14. Should you have any further questions please refer to our websites at aquatruwater.eu,
aquatru.co.uk or call our customer service department at +31 (0)24 20 22 195.
CHECK FOR LEAKS!
15
Under Sink / Maintenance
Note: If the tank is not completely

Publicidad

loading

Productos relacionados para AquaTru ATU100