HyperMotion CLIMBER-6FT Manual Del Usuario página 23

22
EN
Now connect 1 blue bar (A) and 1 yellow bar (B) to 1 yellow bar (B) and 2 blue bars (A) previo-
usly assembled on the first tier (see image below) using a long bolt (E), a washer (H), and one
bolt (K), and tighten with an Allen wrench (I) and a flat wrench (J). The order of the bars needs
to be the same as the order marked in the following picture, the tip of bar 1 is beneath the tip
of bar 2, that bar 2 is beneath bar 3, and so on so that the tip of bar 6 is on the top. Make sure
they are always in a counter-clockwise position.
Repeat this step to finish the second tier.