Saivod DES-223-10L Manual Del Usuario página 66

Maintain the minimum clearance around the dehumidifier when the unit is operating as shown in the left
drawing.
TROUBLESHOOTING
If a condition listed below occurs, please check the following items before calling customer service.
Problem
The unit doesn't
operate
The dehumidifying
function doesn't
work
No air is
discharged
Operation is noisy Is the unit tilted or
E1 Code
66
Possible Cause
Has the power cord been
disconnected?
Is the tank full indication
lamp blinking? (The tank is
full or in a wrong position.)
Is the temperature of the
room above 35C or below
5C?
Is the air filter clogged?
Is the intake duct or
discharge duct obstructed?
Is the air filter clogged?
unsteady?
Is the air filter clogged?
Coil sensor short circuit or
open circuit
Solution
Plug the power cord into the outlet.
Empty the water in the drainage tank and then re-position
the tank.
The protection device is activated and the unit can not be
started.
Clean the air filter as
instructed under
"Cleaning the dehumidifier".
Remove the obstruction from the discharge duct or intake
duct.
Clean the air filter as
instructed under
"Cleaning the dehumidifier".
Move the unit to a stable, sturdy location.
Clean the air filter as
instructed under
"Cleaning the dehumidifier".
Check whether the line is loose or replace the coil sensor.