Publicidad
Idiomas disponibles
Idiomas disponibles
•
Be aware of the risk of open fire and other sources of strong
heat, such as electric bar fires, gas fires, etc. in the near vicinity
of the cot;
•
Do not use the cot if any part is broken, torn or missing and use
only spare parts approved by the manufacturer;
•
Do not leave anything in the cot or place the cot close to another
product, which could provide a foothold or present a danger of
suffocation or strangulation, e.g. strings, blind/curtain cords;
•
Do not use more than one mattress in the cot.
•
Travel cot is ready for use, only when the locking mechanisms are
engaged. Check carefully that they are fully engaged before using
the folding travel cot.
•
If you leave the child in the cot unattended, always check, if the
side entrance is fastened with a zip.
•
All assembly elements and fittings should be tightened properly
and checked regularly and retightened as necessary.
•
To prevent injury from falls, if the child is able to climb out of the
cot, the cot shall no longer be used for that child.
•
WARNING! Only use the mattress sold with this cot, do not add
a second mattress on this one, suffocation hazards.
1.
List of baby cot elements:
1.
Frame
2.
Mattress base
3.
Bag
2.
Assembly:
Undo the zip fastener on the bag (3) and remove the baby cot (1) from the bag (3). To unfold the frame (1) place
it with the cot legs positioned downwards (FIG. A), spread the corners apart enough to be able to grab the
central parts of the sides and firmly pull up the shorter sides until locked (Fig. B). Grasp the central parts of the
longer sides and firmly pull them until locked (FIG. C). Then press the central part of the bottom of the cot,
pointing it down (FIG. D). The frame is completely unfolded and the cot is blocked.
NOTE: Make sure that all four central elements of the sides are locked! The side locking mechanism does not
work when the bottom of the cot is spread out flat. Therefore, when locking the sides, the central part of the
bottom must be raised. Insert the mattress base (2) into the crib (Fig. E), thread the Velcro through the holes in
the floor (Fig. F). Fasten the Velcro fasteners with the Velcro fasteners on the bottom of the crib. To open the side
entrance to the cot, undo the zipper (Fig. G). NOTE: Before the first use, open and close the zipper!
3.
Maintenance and cleaning
12
Publicidad
