Publicidad
ENGLISH
FIG. 1
1
6
2
1.
Test Remote #1 (Red)
2.
Test Remote #2 (Blue)
3.
Test Remote #3 (Green)
4.
Test Remote #4 (Black)
5.
Remote Holder
6.
F-Adapter
7.
Coax Explorer
3
5
4
7
2 Tester (not included)
®
VDV512-110 Instructions
GENERAL SPECIFICATIONS
The Klein Tools Coax Explorer
2 verifies proper continuity of F-connector coaxial cables and
®
maps their location. The color-coded push-on remotes allow for up to four cables to be tested
and mapped, displaying cable status via LED indicators (PASS, OPEN, or SHORT) that also
identify the cable/remote location.
NOTE: The Coax Explorer
2 tester is required, and is not included with this kit.
®
TESTING/MAPPING CABLES
NOTE: Not for use on powered circuits or outlets.
1
2
3
1. Connect a test remote
,
,
tested. If necessary, use the included F-adapter
cable. If mapping, install remaining remotes to additional locations.
2. Connect the opposite end of the cable or outlet to be tested to the F-connector on the
7
Coax Explorer
2
(not included).
®
3. Press and hold the TEST button. If the cable is wired correctly, one of the four PASS LEDs
will light, also indicating the cable/remote location. If there is a problem with the cable,
one of the FAULT LEDs (OPEN or SHORT) will light.
4. Repeat steps 2 and 3 to test/map additional cables.
TESTING AN UNINSTALLED CABLE
6
1. Using the included F-adapter
, connect a test remote
tested.
2. Connect the opposite end of the cable to be tested to the F-connector on the Coax
7
Explorer
2
(not included).
®
3. Press and hold the TEST button. If the cable is wired correctly, the corresponding PASS
LED will light. If there is a problem with the cable, one of the FAULT LEDs (OPEN or
SHORT) will light.
REMOTE HOLDER/STORAGE
The test remotes conveniently snap into the remote holder
included F-adapter
6
, push two remotes onto the adapter before snapping the remotes into
the holder.
The remote holder snaps onto the body of the Coax Explorer
be removed if desired. Hold the tester in one hand and apply slight downward pressure to
one side of the remote holder with the other hand to release it from the tester. To reattach,
align the holder with the tester body and snap back into place.
FCC AND IC COMPLIANCE
See this product's page at www.kleintools.com for FCC compliance information.
Canada ICES-003 (B) / NMB-003 (B)
WARRANTY
www.kleintools.com/warranty
DISPOSAL / RECYCLE
Do not place equipment and its accessories in the trash. Items must be properly
disposed of in accordance with local regulations. Please see
www.epa.gov/recycle for additional information.
CUSTOMER SERVICE
KLEIN TOOLS, INC.
450 Bond Street, Lincolnshire, IL 60069
1-800-553-4676
customerservice@kleintools.com
www.kleintools.com
4
or
to one end of the cable or outlet to be
6
to connect the test remote to the
1
to one end of the cable to be
5
for storage. To store the
7
2
(not included) and may
®
BASED ON 1330431 Rev. 11/21 C
Publicidad
