Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
1
measuring your bathtub space
note: The locations for the mounting brackets (C, D)
will vary depending on the width of the tub opening. Most
bathtubs measure either 60 or 72 in. in length. If your tub
is a different size, refer to the Troubleshooting section at
the end of this manual.
note: Be sure to use a level for this step.
□ Measure the space between the walls of the bathtub
where your shower rod will be installed.
□ Measure up one wall 65 in. above the front of the tub ledge.
□ For 60 in. tub openings:
Using a level, make a mark on the wall directly above the
front of the tub ledge.
□ For 72 in. tub openings:
Using a level, make a mark 2 in. farther in toward the tub.
□ Using a level, lightly draw a vertical line down
approximately 4 in. long.
□ Repeat this process for the other end of the tub.
2
marking the locations for the
mounting brackets
□ Hold the 1 in. mounting bracket (C) against the wall so that
the mark (from step 1) is centered in the top screw hole.
□ Mark the location of the other screw hole along
the vertical line you drew in step 1.
□ Repeat this process for the other end of the tub,
using the 7/8 in. mounting bracket (D).
For 60 in. tub openings
65 in. up from
tub ledge
65 in.
C and D
5
Please contact 1-855-HD-GLACIER for further assistance.
For 72 in. tub openings
2 in.
Tub opening
HOMEDEPOT.COM
Publicidad
