Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
8
Connecting the 7/8 in. tube
□ Fasten the 7/8 in. diameter tube (B) to the 7/8 in. mounting
bracket (D) using end cap screws (BB) and threaded inserts
(CC), and tighten with large hex wrenches (FF).
□ To level the rod assembly, tighten the pre-installed set
screws on the mounting bracket (D) with the medium hex
wrench (GG).
Care and Cleaning
□ Cleaning with a dry cloth may be sufficient.
□ For other stains or marks, wipe gently with a damp cloth.
□ Do not use strong detergents or abrasive cleaners; they may damage the surface of this product.
troubleshooting
□ If the tub opening differs from 60 in. or 72 in. in step 1, follow the chart below.
Tub opening (see step 1)
72 in.
70 in.
68 in.
66 in.
64 in.
62 in.
60 in.
58 in.
56 in.
Inches in toward tub (see step 1)
□ measure 2 in.
□ measure 1-5/8 in.
□ measure 1-3/8 in.
□ measure 1 in.
□ measure 5/8 in.
□ measure 3/8 in.
□ measure 0 in.
□ measure 0 in.
□ measure 0 in.
pre-installed set screws
8
CC
D
B
BB
Publicidad
