Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
5
Inserting the tube plugs
note: This step may be easier if you insert a threaded
insert (CC) through the holes (only to be used as a guide)
before pushing the tube plug (E, F) into place. After
inserting the tube plug (E, F), be sure to remove the
threaded insert (CC).
□ Line up the cut-outs in the tube plugs (E, F) with top and
bottom holes.
□ Insert the 1 in. tube plug (E) into the 1 in. diameter tube (A).
□ Repeat this step using the 7/8 in. tube plug (F) and
7/8 in. diameter tube (B).
6
Connecting the tubes
□ Insert the plastic ring (AA) into the end of the
1 in. diameter tube (A).
□ Insert the end of the 7/8 in. tube (B) into the end of the 1 in.
diameter tube (A).
7
Connecting the 1 in. tube
□ Fasten the 1 in. diameter tube (A) to the 1 in. mounting
bracket (C) using end cap screws (BB) and threaded
inserts (CC), and tighten with the large hex wrenches (FF).
□ To level the rod assembly, tighten the pre-installed set
screws on the mounting bracket (C) with the medium hex
wrench (GG).
E and F
A
C
A
BB
7
Please contact 1-855-HD-GLACIER for further assistance.
A and B
CC
AA
B
CC
pre-installed set screws
HOMEDEPOT.COM
Publicidad
