Publicidad
Step 20
1
D16
S
Groove
Insert the DRAWER SIDES (D16 and D17) at
å
an angle into the slot at each end of the LEFT
DRAWER FRONT (S).
3
Fasten the DRAWER BACK (D73) to the DRAWER SIDES (D16 and D17). Use four BLACK 1-9/16" FLAT HEAD
å
SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D720) inserts into the groove of the DRAWER BACK (D73).
å
Repeat this step for the other drawer using the RIGHT DRAWER FRONT (R).
å
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D17
D73
D16
D720
VIEW THE T-LOCK BOX VIDEO
2
U n
s u
D16
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D720) into the grooves
å
in the DRAWER SIDES (D16 and D17) and LEFT
DRAWER FRONT (S).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D17
416971
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
fi n
i s h
r f a
e d
c e
D720
D17
S
30S
(8 used in this step)
Page 23
Publicidad
