Maintenance And Cleaning - Oster GCSTSP6201 Manual De Instrucciones

(Models GCSTSP6202, GCSTSP6203, GCSTSP6204, GCSTSP6205, & GCSTSP6206)
When the iron is plugged in, the Power Indicator will light steadily, indicating that there is
power to the iron.
IF YOU LEAVE THE IRON:
• in a horizontal position without moving it, or accidentally tip the iron
over, it will automatically stop heating after 30 seconds. The Indicator
light will turn green, beep 6 times and then blink to let you know that
the iron has stopped heating.
• in a vertical position (on its heel rest) without moving it, the iron will
automatically turn off after 15 minutes. The Indicator light will turn
green, beep 6 times and then blink to let you know that the iron has
stopped heating.
Important: The Indicator light will continue to blink until the iron is unplugged or reset.
TO RESET THE IRON:
• Move the iron back and forth and allow it to reheat for 2 minutes. The indicator will stop
blinking and the iron will start heating again.
Warning: The 3 Way Auto-Off is a safety feature, not a recommended means for turning
your iron off.
Before cleaning the Iron, always make sure that it is disconnected from the electrical
wall socket and is completely cool.
SOLEPLATE
• Residue on the Soleplate can be wiped off with a cloth soaked in a solution of water
and vinegar.
• Do not use scouring pads, abrasives or chemical cleaning solvents as they may
damage the finish.
HOUSING
• The housing can be cleaned with a moist cloth and then wiped dry.
• Other than the recommended cleaning, no further user maintenance should be
necessary. If for any reason your Steam Iron should require repairs, do not try to fix it
yourself. Send it to an Oster Authorized Service Center.
3
way Auto-Off Feature

Maintenance and Cleaning

E ng li s h - 9