Publicidad
Idiomas disponibles
Idiomas disponibles
Limited
Edition
Control
Features
Dispenser
Features
o
o
0
0
0
0
SENSOR
FILTER
DISPENSER
FILTERED
ICE & WATER
UGHT
Dispenser
Operation
_
To dispense:
Select CUBE, CRUSH, or WATER mode by pushing button on dispenser control panel. A green indicator light above
button shows mode selection.
Press container against dispenser pad. Selection
mode may not be changed
while ice dispenser
is in operation.
NOTE: If water dispenser is continuously active for more than 5 minutes, an automatic lock out sensor will shut down
power to dispenser area. For instructions on how to unlock your dispenser, see the section entitled "Dispenser Lock"
below.
Dispenser
Lock
_
This feature prevents ice or water from being dispensed.
_
|
To lock and unlock dispenser:
|
To lock dispenser
press and hold LOCK/UNLOCK
button for 3 seconds. A green indicator light above button confirms
|
dispenser
is locked.
/
o
Filter
Status
indicator
Light
The filter status indicator light serves as a reminder to replace the water filter. A green light indicates that the
filter is in good condition. A red light indicates the filter should be changed. Once light turns red. it will remain
red until function is reset.
o
O
Good
Change
FILTER
To reset indicator:
Press and hold both LOCK/UNLOCK
and WATER buttons simultaneously
for 4 seconds, The green filter
status indicator light will flash 3 times when the function has successfully
reset.
Auto
Light
_-o,r_
The auto light function offers the ability to activate the dispenser light at half-power when the
MGHT
LIGHT SENSOR detects that the light levels in room are low.
To activate and deactivate
auto light:
To activate, press ON/OFF button located on control panel. A green
indicator light above button displays to show that sensor is active.
NOTE: Dispenser light will operate whether
or not auto light is selected.
To deactivate, press ON/OFF button. Green indicator light will go out.
Sabbath .ode
÷
This mode is intended to deactivate power to the LED and dispenser lights, while allowing the
controls to remain operational.
To activate and deactivate
Sabbath Mode:
To activate, press and hold both LOCK/UNLOCK
and ON/OFF buttons
simultaneously
for 3 to 4 seconds, After 3 to 4 seconds, the LED and dispenser
lights will turn off Dispenser
light will not activate during dispensing
while in
this mode=
To deactivate, press and hold both LOCK/UNLOCK
and ON/OFF buttons simultaneously
for
3 to 4 seconds After 3 to 4 seconds, the LED and dispenser lights will activate
15
NOTE: in the event that power is
interrupted while the Sabbath Mode
is active, the control will remain in
Sabbath Mode when power returns.
Publicidad
