LG WT6001HV Manual Del Propietário página 15

Connecting the drain line
Secure the drain hose in place to prevent moving and leaking.
NOTE
y The drain hose should be properly secured. Failure to
properly secure the drain hose can result in flooding
and malfunction.
y Total height of the house end should not exceed 96
inches (244.8 cm) from the bottom of the washer.
y The drain must be installed in accordance with any
applicable local codes and regulations.
y Make sure that the water lines are not stretched,
pinched, crushed, or kinked.
Using a standpipe
1
Insert the end of the drain hose into the standpipe.
2
Use a tie strap to secure the drain hose in place.
39"
(99 cm)
Cable Tie
Drain Hose
39"
(99 cm)
Cable Tie
INSTALLATION INSTRUCTIONS
Using a laundry tub
1
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm) from the
end of the drain hose. If the drain hose is extended more than
4 inches (10 cm) beyond the end of the elbow bracket, mold,
or microorganisms could spread to the inside of the washer.
2 Hang the end of the drain hose over the side of the laundry tub.
3
Use a tie strap to secure the drain hose in place.
15
No more than
4 inches (10 cm)
Drain Hose