avide ABLS24VDCOB Manual De Usuario

ABLS24VDCOB
EN DE HU RO SK CZ HR SI SRB PT LT PL GR IT ES FR BG
Thank you for choosing AVIDE product! Please read the following instructions carefully before use.
Prior to assembly, check the LED strip integrity. Do not use the product in case of damage! Switch off the
power supply before installation! When assembling, make sure that the cables are connected correctly.
Do not use the LED strip wrapped or rolled up! We do not accept any liability for non-compliance with the
rules of life and accident protection, or for possible damage resulting from incorrect installation or
damage to the products.
Before installation, please clean the surface where the strip will be installed.
Remove the protective layer and apply the strip. Gently press the strip to the mounting surface until
tightly glued (do not press LEDs, resistors, and controls). The surface where the strip is glued must be solid
and without breaks to avoid damages to the strip.
Please read the product information and check the electrical parameters of the LED strip and the power
supply and controller. For 24V LED strip, use only 24V power supply and controller!
The LED strip has 33,3 mm of cut and solder points. Soldering and cutting is possible at these contact
points. Before soldering, the silicone layer must be carefully removed from the soldering points! When
soldering, make sure that the polarity is correct: "+" indicates positive "- " indicates negative polarity.
Possible installation:
Power supply
33,3mm
Input
LED CONTROLLER
+
-
Output