Operation
3
Operation
3.1
Unit overview
Indoor unit overview
Key to Fig. 2:
[1]
Condensate pump (for draining condensate from the indoor unit)
[2]
Condensate hose
[3]
Display
[4]
Return air inlet
[5]
Air inlet
[6]
Air Outlet
3.2
Indoor unit display
Key to figure 3:
[1]
LED display
[2]
Infrared signal receiver
[3]
Status indicator
[4]
Timer indicator
[5]
Manual operation
[6]
Pre-heating and defrosting indicator
[7]
Alarm indicator
The operating modes can be selected in the sequence automatic mode,
cooling mode and shutdown via the Manual operation key.
Manual button
Operating
Display
mode
Automatic
Operation indicator
mode
on
Manual cooling
Status indicator
mode
flashes
Shutting-down All indicators off
Table 4 Indications on the display unit
3.3
Remote control overview
Keys on remote control
Fig. 3
Pos. Key
Function
1
Switch on/off.
K
Mode
Set operating mode.
2
SET
Select advanced operating functions.
OK
Confirm choice.
Set timer.
Increase temperature.
.
Reduce temperature.
/
42
Display output
Cooling and heating modes: Set
temperature
Fan only mode: Indoor ambient
temperature
The system automatically
switches to automatic mode after
30 minutes of forced cooling.
The remote control is deactivated
during forced cooling.
If the display is switched off, the
indoor unit switches off and the
remote control is reactivated.
Pos. Key
Function
3
Fan step
Swing
Set swing function.
Indirect airflow is active (Wind avoid me).
Turbo cool/Turbo heat
Turbo
Switch display of indoor unit and alarm buzzer on and
LED
off (Mute Mode).
Table 5 Keys on remote control
Display of remote control
Fig. 4
Pos. Symbol Explanation
1
Operating function: Follow Me function is active
(Follow Me); temperature measurement at the
remote control.
Infographic: wireless control function
Infographic: battery status
2
Operating mode: automatic mode
Operating mode: cooling mode
Operating mode: dehumidification mode
Operating mode: heating mode
Operating mode: Fan Mode
Value display: shows the set temperature, fan speed
3
or (when timer is activated) the timer setting as
standard.
Infographic: transmission indicator; lights up when
the remote control sends a signal to the indoor unit.
Infographic: ON/OFF timer active.
Value display: shows the current fan speed. There are
several output stages (bars) and the AUTO setting for
automatic control
4
Infographic: automatic vertical swing function active
(up/down). Alternative display of current position of
horizontal louvre.
Infographic: Turbo cool/Turbo heat is active.
Table 6 Symbols in the display
3.4
Using the remote control
The signal range is 8 m. If objects are in the way or certain fluorescent
lamps are used in the same room this can affect transmission of the
signal.
▶ Point the remote control towards the signal receiver window of the
device and press the desired key.
The device emits a beep when it receives a signal.
NOTICE
The remote control may be permanently prevented from working
correctly.
▶ Do not expose the remote control to direct sunlight.
▶ Do not leave the remote control near a heating appliance.
▶ Protect the remote control from moisture and impacts.
Climate 5000i M – 6721849824 (2022/04)