Nolan N120-1 Seguridad E Instrucciones página 23

- Carefully wash by hand and use only mild soap and water at 30 °C max.
- Rinse using cold water and dry at room temperature, away from direct sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is intended to change or
get partially destroyed to help absorb shocks.
- Do not modify or alter the internal polystyrene components in any way.
- Clean the inner polystyrene components using a damp cloth only and allow them
to dry at room temperature away from direct sunlight.
- Never use tools or equipment to carry out the operations described above.
LINER POSITIONING CONTROL ( LPC )
1 ADJUSTING THE LINER POSITION
The different anatomic shape of riders heads at times requires the position of the hel-
met to be adapted to the specific head. The LINER POSITIONING CONTROL (LPC)
enables the position of the liner to be adjusted. This means that, unlike a standard
helmet, the position of the helmet on the rider's head can be changed without changing
the size of the helmet, making it adaptable to multiple needs.
To adjust the liner, deactivate the VPS, open the chin strap (see relevant instructions)
and proceed as follows.
1.1 Overturn one side of the upper part of the padding and unhook the front circular
button for adjusting the liner below it from the underlying longitudinal plastic sup-
port with seven holes (Fig. 23).
1.2 Move the circular button along the longitudinal plastic support and re-hook it in
one of the two following holes (Fig.24).
1.3 Repeat the process of points 1.1 and 1.2 with the rear circular button located
below the padding (Fig.25). By pulling the two adjustment snaps of the liner, the
helmet is gradually positioned higher on the head.
1.4 After having correctly fastened the two adjustment snaps of the liner to the longi-
tudinal plastic support, fold and spread the upper padding in the correct position.
1.5 Wear the helmet and ensure that the positioning and comfort suit your head. If not,
adjust it again.
WARNING
After adjusting the position of the liner, put on and fasten the helmet to check the cor-
rect adjustment of the chin strap (see specific instruction label under www.nolan-hel-
mets.com). Check also the correct helmet fit on your head in riding position setup,
as well as its easy taking off (see "CHOICE AND VERIFICATION OF THE HELMET"
instructions above).
EYEWEAR ADAPTIVE
1 CREATING SPACE FOR GLASSES
1.1 Remove the left cheek pad from the helmet (see instructions above).
1.2 Remove the inner expanding foam cheek padding (see instructions above).
1.3 Remove the upper part of the pre-punched inner padding (Fig.26), then properly
reposition the remaining part of the padding in the cheek pad.
It is recommended that you keep the removed padding for any subsequent
reuse.
INSTRUCTIONS FOR USE
N120-1
23