Nolan N120-1 Seguridad E Instrucciones página 24

N120-1
1.4 Assemble the inner expanding foam cheek padding (see instructions above).
1.5 Reassemble the full cheek pad on the helmet (see instructions above).
1.6 Follow these operations with the right cheek pad padding.
2 REMOVING SPACE FOR GLASSES
2.1 Remove the left cheek pad from the helmet (see instructions above).
2.2 Remove the inner expanding foam cheek padding (see instructions above).
2.3 Properly insert part of the previously removed padding into the cheek pad fabric
lining (Fig.26).
2.4 Reassemble the full cheek pad on the helmet (see instructions above).
2.5 Follow these operations with the right cheek pad padding.
WIND PROTECTOR
(Available as standard or accessory/spare part)
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
See Fig.27 for assembly and disassembly instructions.
VENTILATION SYSTEM
The ventilation system of the helmet consists of:
Lower ventilation
It allows ventilation around the mouth area and conveys the air directly on the visor,
thus reducing fogging.
See Fig.28 for opening and closing operations.
Top ventilation
It provides direct ventilation to the head upper area, even at low speed.
See Fig.29 for opening and closing instructions.
Rear ventilation
It allows warm and stale air to flow out, thus ensuring an optimum comfort inside the
helmet (Fig.30).
SETTING UP THE N-COM - HELMET COMMUNICATION SYSTEMS
(Available as standard or accessory/spare part)
Your helmet is factory-preset to be equipped with the N-Com communication system.
If your helmet is homologated according to ECE/UN Regulation No. 22, it has also been
tested and homologated with the N-Com system installed. Installing a system other
than the N-Com affects the helmet's regulatory compliance. During the communication
system installation (see the specific instructions in the N-Com kit), it will be necessary
to remove from the helmet the foam material fillers located in the polystyrene cheek
pads next to the N-Com earphones housings.
The above-mentioned fillers should only be removed if the helmet is used with
a compatible N-Com system installed.
24
INSTRUCTIONS FOR USE