Tempo Communications 521E Manual De Instrucciones página 4

IMPORTANT SAFETY INFORMATION
Electric shock hazard:
• Intended for tracing disconnected circuits. At higher output levels, tracing
signal, if applied across electronic devices, may cause permanent damage.
• Do not touch the exposed end of the test leads or cable being traced unless the
transmitter is off.
• Do not expose this unit to rain or moisture.
• Use this unit for the manufacturer's intended purpose only, as described in this
manual. Any other use can impair the protection provided by the unit.
• Use test leads or accessories that are appropriate for the application. Refer to
the category and voltage rating of the test lead or accessory.
• Inspect the test leads or accessory before use. They must be clean and dry, and
the insulation must be in good condition.
• Before opening the battery cover, remove the test leads from the circuit and
shut off the unit.
521E Instruction Manual
Tempo Communications
Fire / Explosion hazard:
Do not use this tool in an explosive atmosphere or connected
to wires entering an area with explosive atmosphere. Failure
to heed this warning could result in severe injury or death.
Electric shock hazard:
• Do not connect the transmitter to any active circuits.
• Avoid listening to the receiver through the headset at high
volume levels for more than a few seconds at a time. Use
only the Tempo recommended headset.
Servicing:
• There are no user serviceable parts within 521E, do not
disassemble.
• High voltages can be present inside the transmitter.
• Contact Tempo's Support Team (details below)
Failure to observe these precautions may result in injury and
can damage the instrument or connected equipment.
4