iTC03 FUNCTIONS
PROFESSIONAL
COMPACT DISC PLAYER
STOP
AUTO CUE
SINGLE/
CONTINUE
+10
TRACK SKIP
SEARCH
CUE
PLAY/PAUSE
STOP: Press this button to stop music
1.
playback.
CONTINUE/SINGLE (AUTO CUE): Press
2.
this button to switch between the SINGLE
and CONTINUE play modes. When
SINGLE/AUTOCUE mode is selected, PLAY 1
is shown on the LCD.
enables the unit to pause at the beginning of
the next track.
+10: Each press of this button advances 10
3.
tracks.
TRACK SKIP: This button selects a specific
4.
track to be played.
SEARCH: Use this button to quickly move
5.
forward or reverse in the song.
CUE: The CUE function allows the CD to
6.
jump to a previously set cue point. Press
the PLAY/PAUSE button to pause the song,
then press the CUE button to set the cue
point. The CUE LED will stop flashing from
the time the CUE button is pressed.
PLAY/PAUSE: Each press of this button
7.
causes the operation to change between
PLAY and PAUSE modes.
DISPLAY This liquid crystal display
8.
indicates the track numbers, time (minutes,
seconds, frames), pitch speed, also other
modes as Single/Autocue and Continue.
TIME/
OUTRO
PITCH
After each track, it
TIME/OUTRO: This button switches the
9.
time display between each Remaining time,
Elapsed playing time, and Total remaining
time; it also switches on and off the OUTRO
function. When the display shows OUTRO,
the player only plays the last 30 seconds of
each track.
PITCH: This button changes the play speed.
10.
Press PITCH button (THE PITCH LED is lit) to
enable the PITCH CONTROL SLIDER to
increase or decrease the playing speed.
When the PITCH is off, the speed
automatically goes back to normal. The
pitch can be changed up to +/- 16% by
moving the slider up and down. NOTE: (1)
The pitch slider will not function if the PITCH
LED is off. (2) This pitch button will not
effect the PITCH BEND buttons below.
PITCH BEND: Press the button for quick
11.
speed up and slow down of the music.
PITCH CONTROL SLIDER: By moving the
12.
pitch control slider, you can achieve the
playback speed you want between MINIMUM
(up side) and MAXIMUM (down side).
DISC COMPARTMENT: For placing the CD
13.
inside on the tray.
OPEN: Press this button to open the disc
14.
compartment door, push the door down to
close.
REAR PANEL
1.
LINE OUT: Connect these to the input
terminals on amplifier or home stereo.
2.
POWER SWITCH: Turns the power on and
off. NOTE: Make sure to follow the proper
power-up and power-down procedures when
using this equipment.
3.
AC POWER CORD: Connect this cord to a
standard AC outlet. NOTE: Do not force or
alter this plug to fit in a non-polarized outlet.