Publicidad
Idiomas disponibles
Idiomas disponibles
Pad Driver
WARNING DO NOT OPERATE MACHINE WITHOUT PAD DRIVER AND PAD IN PLACE .
1 .
Unplug machine, secure handle tube in vertical position, and lay down the machine, turning it over its wheels until the underneath
side of the machine is vertical and fully exposed .
NOTE: Place a clean towel on the floor to keep the switch box from scratching .
2 .
Unscrew the old center plate (located at the lower part of the plate) counterclockwise .
3 .
Insert new center plate and turn clockwise until it is tight .
Pads
WARNING DO NOT OPERATE MACHINE
WITHOUT PAD DRIVER AND PAD IN PLACE .
1 .
Unplug machine, secure handle tube in vertical position, and
lay down the machine, turning it over its wheels until the
underneath side of the machine is vertical and fully exposed .
NOTE: Place a clean towel on the floor to keep the switch
box from scratching .
2 .
Remove the plastic spacer tube (Fig . 4) located at the lower
part of the plate by pulling it outwards .
NOTE: This piece is installed to protect the brush skirt from
damage during transportation .
3 .
Place the pad in position and secure it by using the center
plate, turning clockwise until it is tight .
Dust Control Filter Bags
Model #978LPS20BDC
•
This model includes a dust control system that collects floor
finish dust into a filter bag, maintaining healthier air quality .
•
The filter bag should be changed at least every 6 months or
when the bag has reached about half of its capacity .
1 .
Unplug the machine .
2 .
Open the burnisher's front compartment . (Fig . 5)
3 .
Grasp the used bag and pull it carefully from the connector .
4 .
Place the new bag around the connector and close the front
compartment .
WWW.LAVEX.COM
Fig . 4
Fig . 5
User Manual
6
Publicidad
