Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
CAUTION
It is recommended to familiarize yourself with the machine by working on large, open spaces before
•
attempting tighter spaces .
DO NOT attempt to use this machine with the handle tube in vertical position . It will be uncontrollable .
•
These machines are equipped with overload protection that will shut the motor down if it encounters high
•
amounts of resistance . If this occurs: wait 30 seconds, push the red button (you will hear a click), and the
machine will become usable again .
1 .
Follow all assembly instructions, ensuring that the pad driver and desired pad are properly installed .
2 .
Plug the power cord into a properly grounded outlet that matches the voltage requirements of the machine .
3 .
Place the machine over the rear wheels .
4 .
Turn on the starting switch and push the switch lock, which will start the motor .
5 .
Let the motor run for 5 seconds, then place pad on the floor .
6 .
Keep a firm grip with both hands on the handle grip and guide the floor machine across the desired cleaning area .
7 .
If at any point you wish to turn the machine off, simply release the starting switch and the motor will stop .
8 .
If the pad reduces in size to 1/4" thick, it should be changed . Any thinner and the pad driver could be damaged .
9 .
When finished with the machine, remove driver and pad for cleaning and storage .
Cleaning
CAUTION
Remove the pad driver from the machine BEFORE cleaning .
•
DO NOT use very hot water to clean or a heater/blow dryer to dry, as this may cause deformation of the
•
pad driver .
Pad Driver
1 .
Wash with warm, soapy water .
2 .
Rinse with clean water .
3 .
Shake off excess water and let dry over paper towels .
WWW.LAVEX.COM
User Manual
7
Publicidad
