Publicidad
Sponge filter cleaning
1. Press the lock button and pull the cover to remove it
from the vacuum cleaner. Lift the sponge filter with your
fingers to separate it from the cover.
2. Wash it with a mild soap and water solution and rinse it
with clean water.
3. Let the filter air dry outdoors for 24 hours before
reinstalling it back into the cage.
4. Reinstall the filter. Push the cover until you hear the
locking latch click.
CAUTION
Before cleaning the filter, tap it gently to
remove larger debris.
CAUTION
The filter cleaning process should be done
outdoors, never in inhabited areas.
Problem
The vacuum cleaner is
not working.
Dust is expelled from
the motor cover.
Reduced motor/speed
efficiency and
vibration.
10
ENGLISH
Cause
• No power.
• Defective cable.
• The dust compartment is
full.
• One of the filters is not
placed or is incorrectly placed.
• Nozzle, hose, or container
inlet blockage.
• Clogged filters due to fine
dust presence.
1
Troubleshooting
Corrective action
• Check the power supply, cable, circuit breakers, and fuses.
• Unplug and check the power cable. If damaged, it should be
repaired at an Authorized TRUPER Service Center.
• Empty and clean the dust compartment.
• Place or replace the filters.
• Check the nozzle, hose, and container inlet for any blockages.
• Remove the filters and clean them or install new ones.
• Check the hose pressure regulator position.
2
3
4
Publicidad
