Publicidad
Technical data
Code
Description
Voltage
Frequency
Current
Rated power
Capacity
Vacuum pressure
Conductors
Insulation
WARNING
If the power cable is damaged, it must be replaced by the manufacturer or a TRUPER Authorized Service
Center to prevent any risk of electric shock or significant accidents. The electrical insulation of this tool
is altered by splashes or spillage of liquids during its operation. Do not expose it to rain, liquids, and/or
moisture.
Before accessing the terminals, all power circuits must be disconnected.
WARNING
Power requirements
WARNING
Tools with reinforced insulation are equipped with a polarized
plug (one prong is wider than the other). This plug fits into any polarized outlet and
can only be connected in one way. If the plug does not fit into the outlet, turn it
over. If it still does not fit, contact a qualified electrician or install a polarized outlet.
Do not alter the plug in any way. Double-insulation tools eliminate the need for a
3-wire grounded power cord or a grounded electrical system.
WARNING
When using an extension cord, ensure to use a gauge to carry the current that the tool will consume.
A lower gauge cord will cause voltage drops in the line, resulting in power loss and motor overheating. The following table
shows the correct size to be used depending on the cable length and the amperage capacity indicated on the tool's data
plate. If in doubt, use the next higher gauge.
Capacity
in amperes
From 0 A to 10 A
From 10 A to 13 A
From 13 A to 15 A
From 15 A to 20 A
* It is allowed to use it if the extensions themselves have an overcurrent protection device.
WARNING
When operating electric tools outdoors, use a
extension cord marked as 'Outdoor Use'. These extensions are specially designed for
outdoor use and reduce the risk of electric shock.
Class II
The power cable has cable ties type: Y
The construction class of the tool is: Reinforced insulation
The thermal insulation class of the motor windings: Class B
Number
of conductors
3 (one to ground)
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE.
ASD-180
103191
Canister vacuum
127 V~
60 Hz
10 A
1200 W (1.6 Hp)
0.5 gal (2 L)
17 kPa (2.5 PSI)
18 AWG x 2 C
IP grade
Extension gauge
From 1.8 m to 15 m | Greater than 15 m
18 AWG( * )
16 AWG
14 AWG
8 AWG
grounded
IPX0
16 AWG
14 AWG
12 AWG
6 AWG
Publicidad
