Publicidad
Idiomas disponibles
Idiomas disponibles
Attaching the Lens
For information on how to attach the lens, refer to the
operating instructions for your digital camera.
Attach the lens after turning off the digital camera.
0
Attach the lens after removing
0
the lens rear cap.
After removing the lens from
0
the digital camera, be sure to
attach the lens cap and lens
rear cap to prevent dust and
other particles from
accumulating on or entering
the lens.
∫ Attaching the lens hood
1
Insert the lens hood into
the lens with the short
sides at the top and
bottom.
2
Rotate the lens hood in
the direction of the
arrow to align mark on
the lens hood with the
mark on the tip of the
lens A.
Attach the lens hood by rotating it until it clicks.
0
20
DVQX1990
(ENG)
∫ Removing the lens hood
Rotate the lens hood in the opposite direction to when
0
you attached it to remove it.
Note
When attaching or removing the lens hood, hold it by
0
the short sides.
It is recommended to remove the lens hood during
0
flash photography as the lens hood can block the light
from the flash.
To prevent dropping of the lens, you should never carry
0
the lens by just holding the lens hood.
∫ Notes on filter use
It is possible to attach the lens cap or the lens hood
0
with the filter already attached.
There may be some vignetting in recorded images if
0
multiple filters are attached simultaneously.
It is not possible to attach any items other than filters
0
such as a conversion lens or adaptor to the front of the
lens and use it in combination with this lens.
Lens damage may result if such items are attached.
Publicidad
