Publicidad
EN - Mounting
1.
Place the Mounting Bracket on the
desired location with the arrow
pointing
2.
Mark the holes for screws.
3.
Using a Phillips-head screwdriver
and the provided screws, secure the
Mounting Bracket to the surface.
Optional:
1/4" (6 mm) drill bit to drill holes
where marked, then use the provided
anchors and screws.
4.
For wired setup:
head screwdriver, remove the power
terminal screws, and then thread
them through the metal loops of the
connecting wires. Then, re-tighten the
screws.
5.
For wired setup:
of your existing wiring with the
connecting wires, and then twist the
wire caps over the exposed wiring.
Optional:
wiring is too short, use the provided
Extension Wire instead.
6.
Push the wiring back into the wall
with enough space to fit the wiring
and wire caps.
7.
Press the doorbell into the Mounting
Bracket until you hear a 'click'.
8.
For wired setup:
breaker.
8
B861AJ_QSG_EN-FR-ES_R1.indd 8
B861AJ_QSG_EN-FR-ES_R1.indd 8
.
On drywall, use the provided
Using a Phillips-
Align the ends
If your existing doorbell
Restore power at the
2023-09-22 6:23:52 PM
2023-09-22 6:23:52 PM
Publicidad
