Ford_Kuga
2.0
Fuse
Fuse
5A
15A
Relé
Gas Inlet
WARNING:
- Follow carefully petrol and gas injectors sequence as shown in the diagram.
- Never connect front and back Solenoid Valve cables to the Ground.
- In order to make a front and back Solenoid Valve right diagnostic, don't connect them to each other.
- Never replace fuses with another ones with bigger amperage.
CAUTION:
Be careful with the cars for which the manufacturer prohibits or advises against disconnecting the battery, not to alter the antitheft devices or automatic adaptivity -
Never use welders connected to the battery of the same car - Connect with suitably insulated soft solderings - Position the BRC electrical devices in a well ventilated
area, protected from water seepages and heat sources - We recommend to insulate the BRC electronic control unit wires which are not connected - BRC reserves the
right to modify this diagram without notice - We also recommend you to be sure to have the last revision of the diagram drawn up by BRC.
M.T.M. Srl
SEQUENT DIRECT INJECTION 2.0
Ford Kuga 1.5 16 V 134 kW M9MA CNG
Multipoint Electronic Injection
Changeover
Switch
Cut and
Insulate
Singularly
Gas Pressure
1
2
3
4
and
Temperarture
Sensor
Gas Injectors Sequence
Wiring Diagram
Diagnostic
Point
3
2
1
Cut and
Insulate
Singularly
Pin n° 55 Conn. 103 pin
Pin n° 58 Conn. 103 pin
Pin n° 59 Conn. 103 pin
Pin n° 38 Conn. 95 pin
Pin n° 57 Conn. 95 pin
Pin n° 83 Conn. 95 pin (1° Injector Signal)
Pin n° 84 Conn. 95 pin (1° Injector Positive)
Pin n° 93 Conn. 95 pin (2° Injector Signal)
Pin n° 94 Conn. 95 pin (2° Injector Positive)
Pin n° 88 Conn. 95 pin (3° Injector Signal)
Pin n° 89 Conn. 95 pin (3° Injector Positive)
Pin n° 78 Conn. 95 pin (4° Injector Signal)
Pin n° 79 Conn. 95 pin (4° Injector Positive)
White (MAP)
Sensor
Map sensor
Temperature
DO NOT CONNECT
Water
DO NOT CONNECT
Petrol
Injectors
Sequence
8|8
Date:
Diagram n°:
In place of diagran n°:
Draftsman:
Signature:
Rear Solenoid Valve Connector
White
White
Level sensor connector
Black
Black
Red
Red
Black
Black
Black
Red
Red
+
-
Battery
Petrol
ECU
Pin n° 60
Conn. 95 pin
"VM A3"
HP Level
Sensor
VBA1
30_11_18
//.//.//
I.C.
fusibili
FSM000102R