Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Box contents:
-
Upholstery cleaner
-
Right-angle suction nozzle
-
Water suction nozzle with brush
-
Clean-water tank
-
Waste-water tank
-
Hose hook
-
Water tank cap
-
Instruction manual
3. ASSEMBLY
1.
Insert the hose hook (6) in the device (4). Fig. 3
Remove the clean-water tank (3) from the main body of the device (4). To do so, slide the
2.
clean-water tank release tab (2) and remove the tank (3) in the direction of the arrow
shown in figure 4.
Turn the clean-water tank (3), loosen the cap, and fill the tank with clean water. The
3.
maximum water capacity is 1.2 litres approximately and it is marked in the tank with 'MAX'.
Fig. 5
Install the clean-water tank (3) again in the main body of the device (4). Fig. 6
4.
Insert the hose bracket (8) in the suction nozzle (A/B). The holes on both pieces must
5.
match during assembly. Fig. 7
Warning
-
After filling the tank with water (3), you must tighten the cap correctly to avoid leakage.
-
You can add low-foam detergent to the clean-water tank (3), combined with water in a
5:10 proportion.
-
After using your device, you must empty the remaining water in the clean-water tank (3) to
avoid leakage and mould formation.
-
Do not shake the clean-water tank (3) during installation, as it could cause water leakage.
4. OPERATION
1.
Plug the device into a power supply. Fig. 8
Press the power button (1) to turn the device on. Fig. 9
2.
3.
Hold down the water release button (7) to spray clean water (Fig. 10). Spray clean water
over the dirt to bring it to the surface.
Press the vacuuming inlet (18) on the dirt to bring water and dirt to the surface and
4.
vacuum them. Fig. 11
48
Publicidad
