Black and Decker BWDS Manual De Instrucciones página 20

SET UP & USE
Installing the BLACK+DECKER model BCED15 Dryer on the 3T (DRYER SUPPORT
BAR).
Remove the adhesive back from the (4) rubber spacers and place them so the hole in the
rubber spacer is aligned with the top of the 4 holes of 3T (DRYER SUPPORT BARS) where
the dryer will be anchored to.
Remove the feet on the bottom of the dryer.
Place dryer on top of the rack to align the holes from the previously removed feet with the
holes of the rubber spacer.
Insert 40LD (40mm LONG SCREW) into a washer and insert it upwards through the 3T
dryer support bar, the rubber spacer and through the hole of the dryer. Turn clockwise to
tighten.
NOTE: Follow the same steps to anchor the dryer to all 4 corners of the dryer.
Page 20
Rubber
Spacer
Washer
40LD
Dryer
3T
Rubber Spacer
Washer
40LD
3T
Dryer