Publicidad
Idiomas disponibles
Idiomas disponibles
26 /EN
VII.- HEATER OPERATION
Before using your water heater, make sure you read and follow the instructions in this
manual and all the product labels.
•
Before starting the heater, fill the appliance with water from the water supply.
•
Check visually if there are any possible water leaks.
•
Power the appliance by actuacting the switch.
WARNING:
without water, it will damage the electrical resistance (heating element) and will void the warranty.
Should you not use any water for an extended of time, you should:
• Disconnect the appliance from electrical supply by switching the external switch to "OFF".
• Turn o the plumbing circuit taps
Adjusting the temperature and activating the functions
The product is set a temperature of 70 °C model. The ECO function is active. In case of power
shortages, or if the product is switched o using the ON/OFF buttom " " the product
memorises the last set temperature.
During the healing phase, slight noise may occur due to the heating of the water. Press the
ON/OFF button " " to switch the appliance on.
Use the " " " " buttons to set the desired temperature to a value between 40 °C and 80 °C
as shown on the display. During normal operation, the display will show the temperature reached by
the water inside the produc. During the heating phase, the status indicator is red and turns blue once
the set temperature is reached. If the water temperature drops, for example after a withdrawal, the
heating function will be automatically activated.
ECO Function
The ECO function is a software programme that automatically "learns" the user's consumption
levels, reducing heat dispersion to a minimum while maximizing energy saving. The ECO software
programme requires an initial memorization period that lasts one week, during which the product
starts operating at the set temperature. At the end of this "learning" week, the software programme
adjusts the heater heating according to the user's actual needs, which are automatically identified by
the appliance.
The product guarantees a minimum hot water reserve also when there are no water withdrawals.
The learning process regarding the hot water requirements continues even after the first week. The
process reaches its full e ciency after four weeks of learning.
In order to ensure the programme's correct operations, the product should not be disconnected
from the mains electricity. An internal memory ensures that the data will be stores for a maximum of
4 hours without electricity. After this time, all the acquired data will be deleted and the learning
process will start from the beginning.
make sure your heater is completely full of water before starting it; if you start your heater
.
Publicidad
