MSA GasGard XL Instrucciones Para El Usuario página 19

1 Channel Board Identification Mark
2 Relay Board Identification Mark
3 Setting Icons
5.1.1 Channel Number
If selected, the Channel Number allows user to set channel parameters.
NOTE: The Channel board Identification Mark must be selected by user to confirm that a channel board is inserted in the
slot.
5.1.2 Relay Board Identification Mark
The Relay board Identification Mark must be selected by the user to confirm that a channel relay board is inserted in the
slot:
• Left mark is for the first board
(connected to the Main board), counting from the left
• Right mark is for the second board
(connected to the Sensor Extension board), counting from the left).
5.1.3 Setting Icons
Marking icons enable the user to enter an additional submenu:
Relays setting menu (individual relays modification menu; see 5.1.5 M
Calibration menu (channel calibration; see 5.4 C
General setting menu (general parameters setting; see 5.3 G
Right button [ 8 ]
Up Button [ h ]
Left button [ ESC ]
Down button [ i ]
1. Use control push buttons to select an item to set.
2. Press [ENTER] to confirm the selected item.
NOTE: A selected setting item is inverse and non-blinking.
US
alibration)
eneral Setting Menu)
GasGard XL
5 Configuration
odifying Channel Parameters).
20