Publicidad
Idiomas disponibles
Idiomas disponibles
6 SPECIFIC SAFETY WARNINGS
▪
Do not leave the grinding wheel unattended while it is operating.
▪
Grinding generates sparks, keep away all flammable substances and materials.
▪
Never touch the moving grinding wheel.
▪
The motor is specially rated for intermittent use, maximum 15 minutes continuous use.
▪
Do not attach modules when the grinding wheel is moving.
▪
Do not use the grinding wheel without a module in place
▪
Before removing a module, switch off the power unit and allow the grinding wheel to come
to stop.
7 OPERATION
7.1
High speed steel drill sharpener ((Fig. 1)
▪
Sharpens all high speed steel drill bits from 4-13mm
▪
Unique 'True Point' action ensures accurate finish
▪
Precisely locates high speed steel drills for correct sharpening angles.
▪
Re-sharpens broken drill bits
SHARPENING HSS BIT (1a-1i)
Slide module 'high speed steel drill sharpener' onto the power unit
1.
2.
Remove the clamp from the clamp holder and insert the drill bit (1a)
3.
Tighten the clamping ring slightly so the drill bit is still free to move.
4.
Place the clamp containing the drill bit into the setting slot, using the grooves in the
side to lower it in correctly (1b)
Move the drill bit forward up so it lays in the 'V' guide and touches the metal end
5.
stop (1c)
Turn the drill bit until the 'V' guide fully drops over it (1c)
6.
All 4 drill bit corners should now be touching the 'V' guide sides.
7.
With the drill bit in this position, tighten the clamping ring, so the drill bit can't move
8.
(1d)
Lift up the 'V guide and remove the clamp.
9.
10. Transfer the clamp and drill bit into the clamp into the clamp holder on the Power
Unit module. (1e)
11. Switch the Power Unit on
12. Move the clamp holder from side to side, securing with light finger pressure (1f)
13. Remove the drill bit and holder and turn over (1g)
14. Move the clamp holder from side to side, securing with light finger pressure (1f)
15. Check the leading edge of both flutes are equally sharp. They should meet exactly
in the middle as in (1h) not (1i)
16. Switch the Power Unit off. Before removing the module, ensure the grinding wheel
has stopped.
7.2
Knife and scissor sharpener (Fig. 2)
▪
Sharpens all straight edged knives and scissors
▪
Unique top for sharpening knives
▪
Precisely angled slot for sharpening scissors
SHARPENING KNIVES (2a-2c)
Slide module 'knife and scissor sharpener' onto the power unit
1.
2.
Switch the Power Unit on
3.
Hold the knife handle towards you and insert the blade into guide slot (2a)
4.
As soon as the blade touches the grinding wheel, draw it with light steady pressure
across the wheel. Do not press to hard (2b)
Copyright © 2024 VARO
POWX1350
P a g e
| 5
EN
www.varo.com
Publicidad
