Descargar Imprimir esta página

VARO POWERPLUS POWX1350 Traduccion Del Manual De Instrucciones Originale página 31

Afiladora multifunciones

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
5.
Insert the second side of the blade into the other guide slot (2c) and repeat #4
6.
Repeat sharpening each side until a clean sharp edge is attained.
7.
Switch the Power Unit off. Before removing the module, ensure that the grinding
wheel has stopped.
SHARPENING SCISSORS (2d-2f)
Slide module 'knife and scissor sharpener' onto the power unit
1.
2.
Switch the Power Unit on
3.
Open the scissors fully
4.
Slide the first scissor blade through the front guide slot (2d). Keep the pivot of the
scissors and other blade to the right hand side.
5.
Draw the blade across the grinding wheel from pivot to tip. Use a light steady
pressure, do not press too hard (2e)
6.
Remove and turn the scissor over to sharpen the second blade (2f)
7.
Repeat if necessary, until clean sharp edges are achieved.
8.
Switch the Power Unit off. Before removing the module, ensure that the grinding
wheel has stopped
7.3
Chisel and plane sharpener (Fig. 3)
Regrinds chisel and plane blade up to 50mm wide
Adjustable grinding angle from 15°-50°
Powerful integral magnet to keep the blade secure
Protective shield for added safety
SHARPENING BLADES (3a-3g)
Slide module 'chisel and plane sharpener' onto the power unit
1.
2.
Place the blade against the back lip of the plate (3a). The magnet helps hold in
place.
3.
The sharpening angle must match the existing beveled angle on the blade tip.
Adjust if necessary.
4.
To alter the angle, loosen the angle adjusting knob (3c), adjust the plate and then
tighten the angle adjusting know.
5.
Make sure the blade edge touches the grinding wheel, then switch the Power Unit
on.
6.
Slide the blade and plate with light steady pressure back and forth across the
grinding wheel in a continuous motion (3d). Do not hold the blade stationary, this
causes irregular sharpening.
7.
Gradually adjust the blade down the plate while sharpening (3e). Do not press hard.
Grind gradually. Repeat if necessary.
8.
Remove the blade and make sure the beveled edge and tip are evenly sharp. If not,
adjust the grinding angle. It is important that the sharpening angle matches the
existing beveled angle of the blade. This avoids removing too much mental
unnecessarily and keeps plane blades at their optimum shaving angle (3f)
9.
When sharpening thin chisel blades, place the small chisel guide onto the plate to
act as a spacer and sharpen as before (3g)
10. Switch the Power Unit off. Before removing the module, ensure that the grinding
wheel has stopped
11. Recommend that after grinding, the blade tip is honed on an oil stone.
Copyright © 2024 VARO
POWX1350
P a g e
| 6
EN
www.varo.com

Publicidad

loading