Publicidad
Idiomas disponibles
Idiomas disponibles
8
TROUBLESHOOTING
Switch off and remove the battery before any troubleshooting.
NOTE: The following chart lists problem symptoms, possible causes, and corrective
action if your garden product does not operate properly. If these do not identify and
correct the problem, contact our helpline at 800-541-7027.
PROBLEM
PROBABLE CAUSE
The tool fails
The battery is not secure
to start
Battery is depleted
Possible wiring or electrical
contact problems
The lock-off button is not
pressed before pressing
the trigger switch
The blade is jammed.
The hedge trimmer is not
well connected to the power
head.
The tool stops
The motor is overloaded
while cutting
The battery pack or the
trimmer is too hot
Page 22-English
CORRECTIVE ACTION
To secure the battery pack, make sure
the battery pack snaps into place.
Charge the battery pack.
Remove battery, check contacts and
reinstall the battery pack.
Press down the lock-off lever and hold
it, then press the trigger to turn on the
hedge trimmer.
Remove the battery pack from the tool.
Remove the obstruction carefully and
then reinsert the battery and restart
the tool.
Disconnect the hedge trimmer from the
power head. Reconnect them following
the section"5.31 CONNECT THE
HEDGE TRIMMER ATTACHMENT TO
THE POWER HEAD" in this manual.
Remove the hedge trimmer from the
material. The motor will begin to work
as soon as the load is removed.
Allow the battery pack or the trimmer
to cool down.
GREEN MACHINE 62V CORDLESS HEDGE TRIMMER
The tool stops
The battery pack is
while cutting
disconnected
Battery is depleted
Excessive vibration
Dry or corroded blades
or noise
Blades or blade support
is bent
Bent or damaged teeth.
Loose blade bolts.
GREEN MACHINE 62V CORDLESS HEDGE TRIMMER
Re-install the battery pack.
Charge the battery pack according to
the instructions.
Lubricate the blades
Replace with a new blade or blade
support following the section "5.52
REPLACING THE BLADE" in this
manual or contact the service center
for replacement.
Replace with a new blade following
the section"5.52 REPLACING THE
BLADE" in this manual or contact the
service center for replacement.
Tighten the blade bolts. Using a 3mm
hex wrench (not included), turn the
bolt clockwise to tighten.
Page 23-English
Publicidad
