Descargar Imprimir esta página

Midea MDT24H14ASTC Instrucciones De Instalación página 29

Lavavajillas

Publicidad

Idiomas disponibles

Idiomas disponibles

4.
Use a rubber hose connector* with a screw type clamp* to connect air
gap to garbage disposal inlet.
NOTE: This connection must be located before the drain trap and at
least 20" (50.8 cm) above the floor where dishwasher will be installed.
a
h
*Parts available from local plumbing supply store.
Option 2 – (No Garbage Disposal - With Air Gap):
IMPORTANT: If you need to cut the drain hose to fit the diameter of
the connection, cut only the rubber end of the hose, as shown earlier in
this section (do not cut into the ridged section).
1.
Attach drain hose to air gap with large screw-type clamp. Cut the
rubber end of the drain hose, as needed.
2.
Use a rubber hose connector* with spring or screw type clamps* to
connect air gap to garbage disposal inlet.
NOTE: This connection must be located before the drain trap and at
least 20" (50.8 cm) above the floor where dishwasher will be installed.
a
h
*Parts available from local plumbing supply store.
c
b
d
e
g
f
c
b
d
f
g
e
a
Drain Hose - Cut Here if
Needed
b
Screw-Type Clamps
c
Air Gap
d
Screw-Type Clamp
e
Drain Hose
f
Rubber Hose Connector
g
Garbage Disposal Inlet
h
Drain Trap
a
Drain Hose - Cut Here if
Needed
b
Screw-Type Clamps
c
Air Gap
d
Screw-Type Clamp
e
Drain Hose
f
Rubber Hose Connector
g
Waste Tee
h
Drain Trap
29

Publicidad

loading