GE JKP30 Manual Del Propietário página 22

Careand cleaning of the oven.
Be sure electrical power is off and all surfaces are cool before cleaning any part of the oven.
How to Remove Protective Shipping Film and Packaging Tape
Careflflly grasp a corner of the protective
shipping fihn with your fingers and slowly
peel it fiom the appliance smfhce. Do
not use
any sharp imms
to remove die
film. Remove all of the film befbre using
the appliance for the first time.
To assme no damage is done to tlle
finish of tile product, tile safe.st way to
remove the adhesive from packaging
tape on new appliances is an application
of a household liquid dishwashing
demrgent. Apply with a soft cloth and
allow to soak.
NOTE:Theadhesive mustbe removed fromall
parts.It cannot b e removed if it is bakedon.
Control Panel
It's a good idea to wipe rite conuol
panel after each use. Clean wifll mild
soap and water or vinegar and wam_;
rinse with clean water and polish dry
with a soft cloth.
Do not use abrasive
cleansers, suong
liquid cleansers, plastic scouting pads or
oven cleane_ on the conuol panel--they
will damage tlle finish. A 50/50 solution
of vinegar and hot wamr works well.
Control/(nob (onsome models)
Thecontrol k nobsmaybe removed foreasier
cleaning.
Make sure file lulobs are in die OFF
positions and pull them smdght off the
smms for cleaning.
The knobs can be cleaned in a
dishw_Mler or dley may also be washed
with soap and water Make sure the inside
of tlle knobs are dry before replacing.
Replace the knobs in the OFFposifion to
ensme proper placement.
Slot
Hingeloci(
Pull hinge locks down to unlock
Removal position
22
Lift-Off Oven Door
Thedooris very hea_ Be carefulwhen
removing andliftingthe door.
Donot lift thedoorbythehandle.
Toremove the door:
%
Fully open the door
Pull the hinge locks down toward
tile door flame, to tlle unlocked
position. A tool, such as a small
flat-blade screwdfive,; may be
required.
Firmly grasp bodl sides of the door
at tile top.
Close door to die door removal
position, which is halfi, vay between
the broil stop position and flflly
closed.
[_ Lift door up and out until the hinge
arm is clear of tlle slot.
Toreplacethe door:
[7] Firmly grasp bodl sides of the door
at tile top.
With the Bottom e arm
door at the edge
same angle as 0fslo
the removal
position, seat tlle
indentation of
tlle hinge am1
into the bottom
edge of the hinge
slot. The notch in the hinge am1
nmst be flflly seated into the bottom
of the slot.
%
Fully open the dooI: If the door will
not flflly open, tlle indentation is
not seated correctly in tlle bottom
edge of tlle slot.
[_ Push tlle hinge locks up against tile
flont flame of tlle oven cavity; to tile
locked position.
H122 "%, / ,1
Hinge10cl<
Push hinge locks up to lock
[_ Close tile oven door