GE JKP30 Manual Del Propietário página 28

Before you call for service...
Troubleshooting tips
Possible Causes What To Be
"F--and a number You have a function * Press the Clear/Off pad. Allow the oven to coo] fbr
or letter" flash
error code. one horn: Put the oven back into operation°
in the display If the function • Disconnect all power to the oven for at least 30
code repeats, seconds and then reconnect power. If the flmction
error code repeats, call fbr service.
Oisplayooes blank A fuse in your home may * Replace the fuse or reset the circuit breakeI:
be blown or the ckcuk
breaker tripped.
The clock is in the . See the Special features of your oven control section.
black-out mode.
Bisplayflashes Power failure. * Reset the clock.
Unable togetthe Oven control pads were • The Bake and Broil Hi/to pads must be pressed
display to show "SF" not pressed properly, at the same time and held fbr 3 seconds.
Poweroutaoe, Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes it by pressing the Clear/Off pad, setting the clock
and resetting any cooking flmcdon.
This is normal in a * To speed the process, seta self:clean cycle fbra
odor emitting from
new oven and will mininmnl of 3 hours.
See the Using the self-cleaning
the vent disappear in time. oven secdon.
Strong odor An odor from the insulation * This is temporary.
aroundoven is normalthe insideforOthe f thefirst
few times the oven is used.
Fan noise
A cooling fan may
automatically turn on.
* This is normal. The cooling tim will mrn
on
to cool internal parts. It may run for up to 1-1/2
hours in 30" models and up to 2 hours in 27" models
after the oven is turned off.
28