VelLight LEDA203 Manual Del Usuario página 5

5. Description
Refer to the illustrations on page 2 of this manual.
1
body
2
base
3 screws for base
4
mounting plate
5
screw terminal
6. Installation
To install the luminaire against a wall, proceed as follows:
1. This luminaire does not have a built-in device to disconnect it
from the electric mains. Make sure to electrically isolate the
luminaire before installation or maintenance activities are
performed.
2.
Loosen the screws on the base and pull out the plastic mounting
plate [4].
3.
Use the mounting plate to determine the location of the
mounting holes [6] on the wall. Drill the holes.
4. Pull the mains cable through the cable gasket [7].
5.
Fix the mounting plate to the wall using appropriate screws (not
incl.).
6. Connect the mains cable to the device's power cable via the
screw terminal [5]. Make sure there is no strain on the cables;
leave sufficient slack.
Warning: if the power cable is damaged, it must be replaced by
the manufacturer, his service agent, or a similar qualified person
in order to avoid any hazard.
7. Place the base [2] back over the mounting plate and fix it with
the screws [3].
Caution: make sure the power cable is not crimped.
8.
Tilt the lamp in the desired angle.
7. Cleaning and maintenance
• All screws should be tight and free of corrosion.
• The electric power supply cables must not show any damage.
Have a qualified technician maintain the device.
V. 03 – 22/08/2013
LEDA203
6
screw holes for wall mounting
7
gasket
earth – yellow/green
L
line – brown
N
neutral – blue
5 ©Velleman nv