Descargar Imprimir esta página

Helvex MG GOBI TDS Guia De Instalacion página 2

Publicidad

Instalación General / General Installation
Inserte el taquete (incluido) .
3
anchor (included).
Monte el mingitorio en el ancla.
6
Mount the urinal at the wall bracket.
ancla
wall
bracket
mingitorio
urinal
Si la tuerca del codo SÍ enroscó correctamente con el dispositivo y la inclinación del codo es la adecuada, continúe con el siguiente paso.
If the elbow nut YES screwed correctly with the device and the elbow tilt is appropriate, proceed to the next step.
9
Desmonte el mingitorio.
/ Remove the urinal.
ancla
wall
bracket
mingitorio
urinal
Fije el ancla colocando la rondana y la
/ Insert the
4
pija (incluidas).
by placing the washer and the lag screw
(included).
taquete
anchor
Inserte el codo (incluido) al desagüe.
/
7
Insert the elbow (included) into the drain.
Marque los barrenos faltantes y retire el
10
ancla.
remove the wall bracket.
/ Attach the wall bracket
ancla
wall bracket
pija
lag screw
Corte el codo si es
necesario.
/ Cut the
elbow if necessary.
codo
Ø1 1/2"
elbow
Ø1 1/2"
/ Mark the missing holes and
Inserte el conector ó adaptador (incluido), en
5
el tubo de desagüe a tope.
connector or adapter (included) into the drain
pipe butt.
desagüe Ø 2" /
drain pipe Ø 2 "
conector ó adaptador
para tubo Ø 1 ½" - 2"
(incluido)
/ trap
connector or adapter
for Ø 1 ½" - 2 "pipe
(included)
NOTA /
NOTE:
Si la tubería del desagüe es de un Ø diferente se recomienda
comprar un acoplamiento sanitario o adaptador a la medida
requerida.
If the drain pipe is of a different diameter it is recommended to
purchase a sanitary coupling or adapter as required.
Enrosque la tuerca al dispositivo, verificando
/
8
que la inclinación del codo sea la adecuada
para evitar estancamientos y regreso de malos
olores.
/ Screw the nut to the drain housing,
verifying that the bend of the elbow is adequate
to avoid stagnation and return of bad odors.
Si NO cumple con éstas
condiciones, proceda con el
Ajuste de Instalación (ver pag. 3).
If you DO NOT comply with these
conditions, proceed with the
Installation Adjustment (see page 3).
dispositivo
drain housing
tuerca
inclinación
conector ó adaptador para tubo Ø 2" (incluido)
trap connector or adapter for Ø 2" pipe (included)
Barrene en la marca con broca de Ø 5/16"
11
para concreto (no incluida).
Ø 5/16" drill bit for concrete (not included).
/ Insert the trap
tubería del
El tubo del desagüe
debe estar rígido y fijo
al muro.
/ The drain
pipe must be rigid and
fixed to the wall.
/ nut
/ inclination
/
/ Drill in mark with
2

Publicidad

loading

Este manual también es adecuado para:

Mg negev tds