ASSEMBLY INSTRUCTIONS
1. Press the release lever on slides (Q) and remove slide
runners.
Note: Save the slide runner for the drawer
assembly (Step 11, page 9). The self closing slide (Q)
will be installed in step 4 below.
2. Insert large wood dowels (GG) into mounting cleats (H).
Hardware Used
Large Wood Dowel
GG
3a. Insert barrel nuts (HH), large wood dowels (GG) and
large cam bolts (WW) into upper left side panel (A) and
upper right side panel (B) as shown.
3b. Attach upper left side panel (A) and upper right side
panel (B) to lower left side panel (C) and lower right
side panel (D).
3c. Insert large cam locks (VV) into lower left side panel (C)
and lower right side panel (D) to secure panel assembly.
Hardware Used
Large Wood Dowel
GG
Barrel Nut
HH
Large Cam Lock
VV
Large Cam Bolt
WW
1
UP
Release Lever
Q
2
H
GG
x 4
3
VV
HH
GG
x 4
WW
D
x 4
B
x 4
A
x 4
6
ASSEMBLY INSTRUCTIONS
4. Attach slides (Q) to lower left side panel (C) and
lower right side panel (D), securing with M6 x 10 mm
screws (PP).
Hardware Used
M6 x 10 mm Screw
PP
5a. Insert barrel nut (HH) into mounting cleat (H).
5b. Secure mounting cleat (H), beveled edge down, to
upper right side panel (B) where shown with lock
washers (CC), small flat washers (DD) and M6 x 60
mm bolts (BB).
5c. Attach the middle fixed shelf (G) and top/bottom fixed
shelf (E) to upper right side panel (B) and lower right
side panel (D) with lock washers (CC), small flat
washers (DD) and M6 x 40 mm bolts (AA).
5d. Tighten all connections with allen wrench (SS).
Hardware Used
M6 x 40 mm Bolt
AA
M6 x 60 mm Bolt
BB
Lock Washer
CC
Small Flat Washer
DD
Barrel Nut
HH
Allen Wrench
SS
6. Repeat step 5 for upper left side panel (A) and lower
left side panel (C).
Hardware Used
M6 x 40 mm Bolt
AA
M6 x 60 mm Bolt
BB
Lock Washer
CC
Small Flat Washer
DD
C
Barrel Nut
HH
Allen Wrench
SS
4
PP
Q
x 4
D
Q
5
SS
AA
CC
BB
DD
HH
x 7
CC
DD
x 1
AA
CC
x 8
DD
B
x 8
D
G
x 1
E
Beveled edge facing
x 1
bottom of unit
6
x 7
A
C
x 1
x 8
DD
AA
x 8
CC
x 1
CC
BB
x 1
7
PP
C
H
E
HH
CC
DD
AA
SS