Publicidad
Idiomas disponibles
Idiomas disponibles
2.3 Installation procedure for the lower case.
Route the wire through top center outlet before installing lower case onto the wall. Install
the lower case onto wall using the screw provided. Ensure the wire is not overly pressed
against the wall by lower case.
NOTE
• Install the control on a fl at surface only.
• To prevent deformation of the lower case, avoid over-tightening the installation
screws.
2.4 Install the upper case.
• Connect the wire to connector (CN_WIR) on printed circuit board as shown below.
Connector
CN_WIR
• Then align the upper case with tabs of the lower case, insert and press the upper
case onto lower case until it is firmly attached.
• Peel off the protective membrane which overlays the upper case.
Wire route to indoor unit
Screw
CN̲WIR
4
Publicidad
