Bestop Sunrider Instrucciones Para La Instalación página 6

Section 4 Attach SRHT Attach Brackets
Inside front edge of Hard Top
Remove Hardtop Latch Receiver Screws
and retain for future Hardtop installation.
P6 - 52460 Rev L 0424
T40 Torx Driver
Place the M8 X 16mm washers between the attach bracket and
the hard top then install the M6 X 25mm screws. Tighten all four
screws at this time.
Installation Instructions - Sunrider for Hardtop
T40 Torx Driver
Attach the Center Halo Bracket to the Sunrider
using two (2) M8 X 25mm Screws and two (2)
M8 washers. Leave loose at this time.
Page 6
4mm Hex Key
© 2024 Bestop, Inc.