Publicidad
Idiomas disponibles
Idiomas disponibles
Your Bestop product is made of the finest materials available. To keep it looking new and for the maximum possible wear, it will need
periodic cleaning and maintenance.
Fabric:
The fabric should be washed often using soap, warm water and a soft bristle brush Rinse with clear water to remove all traces
of soap. Bestop recommends using Bestop Cleaner (part no. 11201-00) and Bestop Protectant (part no.11202-00) for Vinyl fabric and
Bestop Twill Protectant (part no. 11207-00) for Twill fabric. Bestop Cleaner and Bestop protectant are specially formulated to provide a
total cleaning and protection system. Bestop Cleaner safely removes the toughest stains, will not harm vehicle finishes, is biodegradable
and environmentally friendly. Bestop Protectant protects against UV-fading, cracking and hardening, and repels dust, grease, dirt and
mildew.
Windows:
Keep windows clean to avoid scratching. DO NOT use a brush on the windows! Wash with a water-soaked cloth or sponge
and a mild dishwashing detergent. Bestop recommends Bestop Vinyl Window Cleaner (part no. 11203-00), which safely cleans and
protects vinyl windows and helps prevent UV damage. NEVER WIPE THE WINDOWS WHEN THEY ARE DRY. Be careful when cleaning
snow or frost from the vinyl windows since they are easily scratched and may crack at low temperatures. DO NOT roll the sides or rear
window in cold weather. The windows become stiff and will crack. Cracks caused by misuse in cold temperatures are not covered under
warranty.
Water:
Seeping through at the seams may be stopped by applying 3-M Scotchgard® on the inside of the seams.
Snaps:
Keep snaps cleaned and lubricated with silicone to help prevent snaps from sticking to the studs. If a snap does become stuck
to a stud, use a screwdriver and GENTLY pry apart to prevent permanent damage to the snap or the top fabric.
Zippers:
Keeping zippers cleaned and lubricated with Bestop's Zipper Cleaner
(part no. 11206-00) will help prevent damage and keep the zippers in smooth work-
ing condition. If a zipper opens behind the slider, the slider may have been spread
apart. This problem can usually
be repaired by using an ordinary pair of pliers to bring the sides back into parallel.
Return slider to the end of the zipper in the normal Open position. Squeeze lightly
at first and test the zipper. If the zipper continues to remain open squeeze more
firmly with the pliers and try the zipper again. Repeat this procedure until the zipper
operates correctly.
For Bestop Warranty Information, Please go to;
https://www.bestop.com/help/warranty-information/
Care and Maintenance of your Bestop Product
Normal Slider-
Jaws Parallel
Damageed Slider-
Jaws spread apart
(Sometimes broken)
Publicidad
