Silvercrest SHBS 3.7 D5 Instrucciones De Servicio página 25

Do not detach the shaving foil from the
shaving foil frame, and do not clean it
using the brush.
Do not use any astringent or abrasive
cleaning agents.
4. Items supplied
1 5-in-1 hair and beard trimmer 6
1 Power unit 12
1 Battery charger 13
5 Interchangeable cutting attachments:
hair trimmer attachment 15
beard trimmer attachment 16
precision trimmer attachment 5
nose/ear hair trimmer attachment 14
shaving attachment 4
4 Comb attachments 2 for the hair trimmer
attachment 15: 3, 6, 9, 12 mm
1 Comb attachment with dial (1 - 10 mm) 3
for the hair trimmer attachment 15
1 Adjustable (3, 4, 5, 6 mm) comb attach-
ment 1 for the beard trimmer attach-
ment 16
1 Comb 20
1 Scissors 17
1 Cleaning brush 19
1 Blade oil 18
1 Storage bag (for the hair and beard trim-
mer and its accessories) 21
1 Operating Instructions
5. Charging
NOTES:
• Before first use (without cable), and for
every charging procedure afterwards,
charge the hair and beard trimmer 6 for
approx. 90 minutes.
• The hair and beard trimmer also charg-
es, when it is switched off and connect-
ed directly via the power unit 12 to a
wall socket.
• When the batteries are almost empty,
the plug symbol 10 flashes in red. The
device can then only be used for a short
time without being connected to the
electricity supply.
1. Place the battery charger 13 on a level
surface.
2. Connect the power unit 12 to the bat-
tery charger 13.
3. Switch off the device with the on/off
switch 8 if necessary.
4. Insert the power unit 12 into a readily
accessible wall socket whose voltage
matches the voltage stated on the rat-
ing plate.
5. Put the hair and beard trimmer 6 into
the battery charger 13 and press it
down until the plug symbol 10 is lit red
and the battery is charged.
6. When the battery is fully charged, the
battery symbol 9 flashes in green.
When the battery is fully charged, the
device can be used for approximately
60 minutes without being connected to
the power supply.
23
GB