Silvercrest SHBS 3.7 D5 Instrucciones De Servicio página 26

6. Operation
NOTE: figure F: for all applications hold
the shaver with an angle of 45° to your skin.
Regardless of the charging state of the bat-
tery, the hair and beard trimmer can always
be mains-operated.
1. For mains operation, ensure that the
hair and beard trimmer 6 is switched
off.
2. Connect the power unit 12 to the con-
nector of the hair and beard trimmer 6.
3. Insert the power unit 12 into a readily
accessible wall socket whose voltage
matches the voltage stated on the rating
plate.
4. Switch on the device with the on/off
switch 8.
NOTE: when the hair and beard trimmer re-
mains connected to the wall socket after be-
ing switched off, it will be charged
automatically.
6.1 Transport safety lock
When the transport safety lock is activated,
the lock symbol 11 flashes blue 3 times.
• Press and hold the on/off switch 8 for
approx. 4 seconds to activate/deacti-
vate the transport safety lock.
• By connecting the power unit 12, the
transport safety lock is deactivated, and
also cannot be activated while plugged
in to the power supply.
24 GB
6.2 Changing the cutting
attachments
WARNING! Risk of injury!
Switch off the hair and beard trim-
mer 6, before you attach or remove the
attachments.
• Figure A: to remove the attach-
ments 4, 5, 14, 15, 16 use your
thumbs to press the attachment towards
the rear of the hair and beard trim-
mer 6.
• Figure B: to attach the attachments,
put the lower flap of the attach-
ment 4, 5, 14, 15, 16 into the slot in
the hair and beard trimmer 6 and press
the upper part of the attachment against
the hair and beard trimmer until it audi-
bly locks into place and sits firmly in po-
sition.
6.3 Changing the comb
attachments
Pushing on
• To attach the comb attachments 1, 2, 3
carefully slide the appropriate comb at-
tachment over the hair or beard trimmer
attachment 15/16. Press the lower part
of the comb attachments 2 + 3 firmly
until they lock into place.
Removing
• To remove the comb attachments 2 + 3
loosen the comb attachment at its lower
end and pull it off the hair and beard
trimmer 6.
• Slide the comb attachment 1 for the
beard trimmer attachment 16 upwards
from the hair and beard trimmer 6.