Xblitz S10 DUO Instrucciones De Uso página 14

EN
USER MANUAL
VIDEO RECORDER
Carefully read the enclosed operating instructions and safety notes before use to
avoid accidental damage to the equipment or unintentional injury.
PURPOSE OF THE PRODUCT
The Xblitz S10 Duo car camera, together with a secondary camera, allows you to
monitor your vehicle's route and record any traffic incidents. The second camera
can be used e.g. as a reversing camera, the set includes an active bracket with
which the camera is powered, making it easy to install and remove the device. The
video recorder is made from the highest quality components.
BEFORE USE
1. It is recommended to use original micro SD cards of class 10 or higher.
2. Before placing the memory card in the recorder, it must be formatted in the
computer in the FAT32 or exFAT file system (depending on the card) and
then in the recorder.
3. The memory card must be installed when the device is switched off. Failure
to do so may damage the card and the device. The same applies when
removing the card from the device.
4. Set in the menu:
a. Date and time.
b. Loop recording (adjust recording time). If you disable loop recording, the
files will not be overwritten.
c. Set the highest resolution available.
d. Set the G-Sensor to the lowest possible sensitivity so that the camera does
not catch bumps in the road and secure unnecessary recordings.
e. Enable WDR mode.
5. When the memory card fills up, the oldest unprotected recordings are
overwritten.
6. The camera will start recording automatically every time you switch it on
(provided there is no permanent power supply in your car's cigarette lighter
socket).
7. It is recommended to use the functions of the device according to their
intended use, that is, not to use the PARKING MODE and MOVEMENT
DETECTION functions while driving. This may cause the recording to start
14