Xblitz S10 DUO Instrucciones De Uso página 21

or „60Hz" depending on local settings.
10. Bracket detaches from glass/does not stick to glass
Degrease the surfaces well before mounting the mount on the glass.
Remember to avoid high temperatures, which can cause deformation of the
holder, and damage to the recorder itself.
NOTES:
- G-SENSOR - a function thanks to which recordings with recorded overloads (e.g.
uneven road surface, braking, driving off a kerb or over a speed bump, etc.) are
protected from being overwritten. If you use this function, you must periodically
format the memory card on your computer and then on the camera. Ultimately,
each file on the data carrier will be protected from being overwritten and the devi-
ce will not be able to record a further route - it will not record in a loop. We suggest
setting the sensor according to your driving style and road conditions. The option
can also be completely disabled, in which case each oldest file will be overwritten
and the card will not need to be formatted periodically.
- PARKING MODE/MONITOR - a function designed to operate while the vehicle is
parked, uses battery power* if the DVR is fully charged - (*if it has a built-in battery)
. In this case, the camera starts recording a few seconds of video after detecting a
shock - until the battery is discharged. When using this function, bear in mind the
battery of the device, which needs to be charged after the function is activated
(started). You should deactivate the function, before setting off on a journey, as
it may cause the camera to switch on and off and make random fragments of
recordings from the route.
*The constant power supply in the vehicle may cause this function to behave
differently, e.g. leaving the camera on, which may drain the car battery.
- MOVEMENT DETECTION - a function designed to operate while the vehicle is par-
ked - requires constant power and the camera must remain switched on. The DVR
will start recording automatically when motion is detected, and will stop recording
a few seconds after there is no movement in front of the camera lens. Please note
that this function may drain the car battery.
You need to deactivate the function, before setting off, as it can cause the camera to
switch on and off and make random fragments of route footage.
ATTENTION: The device has a built-in capacitor and only works with an external
power supply.
NOTE: Use only the original charger with a charging current of 5V/2.5A. (Do not
connect directly to a 220/230V socket). Failure to follow the instructions may
damage the camera or lead to dangerous situations.
21